ASTM D 3299 PDF

Buy ASTM D REDLINE Standard Specification for Filament-Wound Glass-Fiber-Reinforced Thermoset Resin Corrosion-Resistant Tanks from SAI. Dec 2, One of the most com- monly used specifications for filament- wound FRP tanks is ASTM D This standard was first published in and. For Filament Wound Fabrications: ASTM D Specification for Filament Wound Glass. Fiber Reinforced Thermoset Resin Chemical Resistant Tanks.

Author: Faer Shajind
Country: Liberia
Language: English (Spanish)
Genre: Medical
Published (Last): 18 April 2008
Pages: 146
PDF File Size: 6.56 Mb
ePub File Size: 3.99 Mb
ISBN: 259-3-35769-799-6
Downloads: 78560
Price: Free* [*Free Regsitration Required]
Uploader: Taugrel

It is the responsibility of the fabricator, using a thixotropic agent in the resin required for 7. There is no known ISO equivalent to this standard.

NOTE 11—Tanks with unsupported bottoms require special design consideration. This c, tr, may be applied to the outer or inner surfaces, or be divided between them as shown in Fig. Laminate Construction Requirements 7. While Design Tanks has elected not to seek certification at this time, we meet and exceed many of the RTP-1 standards without the additional costs associated with certification.

Design Tanks stores resins in a climate-controlled storage area to eliminate production variances related to temperature changes. Just two of the many ways Design Tanks rises above the fray aastm additional costs to our customers! Nozzle Inside Diameter Up to 10 in. NOTE 10—Tanks with signi? NOTE 16—Special vent sizing consideration should be given to the numerous operating situations that could otherwise cause a positive or a negative pressure in a closed tank.

  KINGSHIP AND THE GODS FRANKFORT PDF

In addition, this clearance shall not be less than the shear distance required for proper installation of the nozzle see 7. In environments that attack glass, the use of an organic-?

Resources & News

Included are requirements for materials, properties, design, construction, dimensions, tolerances, workmanship, and appearance. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters.

The use of woven roving is optional. Contact-molded laminates shall satisfy the minimum astk requirements listed in Speci?

ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. As a custom aetm specializing dd meeting the unique needs of our customers, our exposure to these different standards is much higher than for the manufacturer that produces a cookie cutter tank.

The bottom laminate surface shall be a hand-work? Fluid level in the tank is an important consideration in the analysis.

The Design Tanks Difference: Exceeding The Standards | Design Tanks

The designations of these speci? Materials and Manufacture 5. For nozzles less asym 6 in. Laps in subsequent layers shall be staggered at least 2. They do, however, require foundation cut-outs of the appropriate dimensions for the nozzle type and size.

  BULA DORFLEX PDF

A line of support is the following: Absence of a designation of type required shall imply that Type I is adequate. Tolerances on installation are shown in Fig. Prior to hoisting the top end, a suitable protection pad of f should be placed under the bottom pivot point of tank so that as the tank rises, the strain is taken on the pad. Other techniques such as sprayed, wrapped, or overlaid?

The thickness of the? The design number and attachment of such lugs is the responsibility of the fabricator, based on the wind, seismic, and other loads speci? NOTE 21—The use of organic reinforcing materials may reduce the Barcol hardness readings without necessarily indicating undercure. Overall thickness, mm astj shear lengthmm A 14?